Batten Cap U-Panel
- 29
- March
- 2014
- By JewelsADV
- Standing Seam Panels
- Comments Off on Batten Cap U-Panel
This easy-to-install system has no left or right, top or bottom, making them fast and easy to install. A distinctive formed, double hem standing seam batten cap locks on and stays on. This concealed clip fastening system is capped with a narrow, low-profile snap on batten that provides a thin line appearance which allows the designer freedom to specify radius or high profile features. The U-Panel profile features a 1” or 1-1/2” leg height. (Optional flat rib stiffener is available)
Available in:
24 Ga.
.032 Kynar 500®
See the Color Chart
To Order Call: (231) 861-0050
A twenty year warranty is available covering cracking, peeling and color fade.
Descriptions of the products are for informational purposes only and are not warranties. ADVANCED Architectural Sheet Metal & Supply does not build or design buildings but rather acts solely as a supplier of materials and assumes no responsibility for the use or installation of the aforementioned products.
Panel specifications can be obtained by calling us at 231-861-0050. For complete product and detailed information call us at 231-861-0050 or 877-756-4890.
Standing Seam Snap on Panels have been designed for use in roofing, mansard and fascia applications and are ideal for applications where roof transitions are required. There is simplicity in the panel design which allows for greater handling on the job site.
Special care must be taken to insure the panels are installed over a flat substrate.